
OctoPrint – Flashforge Creator Pro 2
Before we start, it’s important for you to note that this isn’t a supported setup for the Flashforge Creator Pro 2 to work with OctoPrint, it’s more of a work around. So it’s completely at […]
Before we start, it’s important for you to note that this isn’t a supported setup for the Flashforge Creator Pro 2 to work with OctoPrint, it’s more of a work around. So it’s completely at […]
Out of the box, OctoPrint / OctoPi works with ethernet, but to run it over wi-fi, you need to make a few simple changes. So let’s get started: Step 1 Connect your OctoPi Micro SD […]
If you have a 3D printer without an IP connectivity (e.g. ethernet / wi-fi), but you’d like to gain some remote control and monitoring, then OctoPrint will help you. Essentially, you connect a Raspberry Pi […]
If you’ve just installed Pi-hole, this article will help you with changing some of the default settings and improving what gets blocked. It’s important that you do not change the DNS settings on your DHCP […]
If you’re reading this article, I’m presuming that you know what Pi-hole is, and have a Raspberry Pi setup with Docker installed. Pi-hole features and benefits I think the main reasons most people will install […]
This process should be pretty similar, regardless of the device, so long as you have Docker installed, but this image is specifically designed for the Raspberry Pi. Prerequisites You will need Docker installed on your […]
Running software in a container, instead of directly on a computer/server has many benefits, as you likely know, since you’re reading this. But for me, one of the key things is the separation. I like […]
Copyright © 2021 | Richard Wallace