If you followed my other guide on how to install Pi-hole in a docker container on a Raspberry Pi, then this guide will help you to upgrade it. If you didn’t setup Pi-hole using my […]
Out of the box, OctoPrint / OctoPi works with ethernet, but to run it over wi-fi, you need to make a few simple changes. So let’s get started: Step 1 Connect your OctoPi Micro SD […]
If you have a 3D printer without an IP connectivity (e.g. ethernet / wi-fi), but you’d like to gain some remote control and monitoring, then OctoPrint will help you. Essentially, you connect a Raspberry Pi […]
If you’ve just installed Pi-hole, this article will help you with changing some of the default settings and improving what gets blocked. It’s important that you do not change the DNS settings on your DHCP […]
If you’re reading this article, I’m presuming that you know what Pi-hole is, and have a Raspberry Pi setup with Docker installed. Pi-hole features and benefits I think the main reasons most people will install […]
If you’ve just installed Homebridge, this article will help you with changing some of the default elements, before you start adding plugins. Logging into Homebridge To login to Homebridge, you need to visit the below […]
This process should be pretty similar, regardless of the device, so long as you have Docker installed, but this image is specifically designed for the Raspberry Pi. Prerequisites You will need Docker installed on your […]
Copyright © 2021 | Richard Wallace
