I’m a 3D printing noob, so these articles are just about sharing my experiences and some tips I’ve found along the way.
So I’ve had the Flashforge Creator Pro 2 for a couple months now, and I’m still enjoying it. I’ve not really done much practical with it yet, but I’m still having fun with my prints. […]
Before we start, it’s important for you to note that this isn’t a supported setup for the Flashforge Creator Pro 2 to work with OctoPrint, it’s more of a work around. So it’s completely at […]
After printing a ton of stuff in PLA, I thought I’d try printing with a different material in my new Flashforge Creator Pro 2. I thought about ABS, but after doing some research online, temperature […]
I’m fairly new to the world of 3D printing, but wanted to get into it as a hobby, but also because I need plenty of brackets for the smart tech installed around my home. After […]
Out of the box, OctoPrint / OctoPi works with ethernet, but to run it over wi-fi, you need to make a few simple changes. So let’s get started: Step 1 Connect your OctoPi Micro SD […]
If you have a 3D printer without an IP connectivity (e.g. ethernet / wi-fi), but you’d like to gain some remote control and monitoring, then OctoPrint will help you. Essentially, you connect a Raspberry Pi […]
Copyright © 2023 | Richard Wallace
